This is the main filtering unit:
This is the pump section that is going to be inside the tank:
This is the return pipe. I used the intake tube off of a HOB filter to keep from having to use another sharp bend in the pipe, and to help keep it on the back of the tank without falling off
As ever paranoid as I am, I drilled holes in the intake tube/return tube so that there wouldn't be any way for a syphon to start in the tube and start draining water out of the tank because the bottom of the tube is going to be underwater. May not have happened, but now it can't.
This is a close up of the bottom of the duetto motor. The sponge stick fit right into the bottom of it with just a little bit of effort (and a file). I still dabbed a little bit of hot glue just as a temp meassure to make sure that it was going to intake water where it should. The zip ties are just to make sure that the impeller is going to stay where it should as well.
